Craftsman CompuCarve 133.217540 Manual do Operador descarregar pdf (Página 12)

Sears, Roebuck and Co. CompuCarve™ System (Rev 1.18) 04/23/07

6. Prepare cutting bits: The 1/16” Tapered carving Bit and the 1/8”

Cutting bit will come assembled into the bit adapters. The setscrews

will be secured with permanent thread cement. Do not attempt to

loosen as the hex socket on the setscrew will likely strip. To

replace a broken bit or to mount other purchased un-assembled bits,

please see the section titled Bit Adapter Assembly in this manual.

7. Attach muffler and dust collector bag: Insert the muffler bag into

the vacuum outlet on the rear of the machine by pressing and twisting

it into place.

8. Plug the power cord into a wall outlet.

9. Make sure that the outfeed tables are adjusted correctly. Fold

the outfeed trays down and check that they are adjusted to the correct

height. To check, place a flat piece of material across the two belt

drive trays and verify that the rollers on the outfeed trays are just

below the material. Adjust if necessary.

10. Store packaging: Please keep the box and packing foam for secure

transportation to the service center in the event that the machine

needs service.

FIGURE 9: INSERTING THE

FLEXSHAFT

Shaft Rece

tacle

End Of Flexshaft

Assembly

Ball Detent

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 45 46

Sem comentários

Craftsman CompuCarve 133.217540 Manual do Operador Página 12