Craftsman 919.161020 Instruções de Operação descarregar pdf (Página 6)

Operatinq The Paint Tank (cont')

PRESSURE REGULATOR

(DO NOT EXCEED 80 PSI)

AIR

AIR REGULATOR (RECOMMENDED,

/ NOT INCLUDED)

AIR COMPRESSOR

WITH REGULATOR

AIR FILTER

(RECOMMENDED,

NOT INCLUDED)

MATERIAL HOSE

(INSIDE PAINT TANK)

Cleaninq Instructions

Always shut off air pressure at source and

bleed off all pressure in Paint Tank by

gently pulling safety valve ring before

loosening thumb screw and clamps to re-

move lid.

Itis very important that the tank, material hose, and spray

gun be cleaned as soon as spray job is finished. Turn off

the main air supply to the tank. Remove all pressure from

the tank by pulling the ring on the safety valve until the

pressure bleeds down. Turn the T-handle adjusting screw

on the regulator counter-clockwise until no spring tension

is felt.

Loosen thumb screws, tip clamps back and tip tank lid to

one side. Loosen spray gun air cap retaining ring about

three turns then turn on the air supply. Cup cloth over air

cap on the gun and pull trigger. This will force the material

back through the hose, into the tank. Empty and clean

tank and parts which come in contact with the material.

Use a suitable solvent. Pour solvent into the tank.

Replace lid and tighten the thumb screws and clamps

and spray until clean solvent appears.

6- ENG

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Sem comentários

Craftsman 919.161020 Instruções de Operação Página 6