Craftsman 113.298720 Instruções de Operação descarregar pdf (Página 35)

RE;SAWING

RESAWING is known as ripping a piece of wood

through its thickness. Do not attempt to resaw

BOWED or WARPED material. NOTE: To RESAW a

piece of wood wider than 3-3/8 inch . . . it will be

necessary to remove the blade guard,,, and use the

AUXILIARY FENCE/WORK SUPPORT (See "Work

Helpers").

Clamp itto the table so that the workpiece will SLIDE

EASILY but not TILT or MOVE SIDEWAYS without

BINDING between the two fences.

Do not clamp directly to the bottom edge of the table

because the "swivel" of the clamp will not grip

properly. Place a small block of wood between the

bottom edge of the table and the "C" clamp.

WARNING: FOR YOUR OWN SAFETY,..

1. DO NOT "BACK UP" (REVERSE FEED)

SMALL BLOCK

OF WOOD

2. MAKE FIRST PASS TO A DEPTH SLIGHTLY LES.€

THAN ONE-HALF THE WIDTH OF THE BOARD

KEEP SAME FACE OF BOARD AGASINT FENCi

FOR SECOND PASS AS THE FIRST PASS.

3. INSTALL BLADE GUARD IMMEDIATELY UPOI_

COMPLETION OF THE RESAWING OPERATION

CUTTING PANELS

When cutting panels (whenever fence is positioned

outside of table surface), ALWAYS use the AUX-

ILIARY PANEL/WORK SUPPORT.

1. Unlock fence and raise rear end.

2. Position AUXILIARY FENCE/WORK SUPPORT

as shown and attach it with two "C" clamps.

AUXILIARY PANE

USING FEATHERBOARDS FOR

NON-THRU SAWING

Featherboards are not employed during non thru-

sawing operations when using the miter gauge.

Use featherboards for all other non "thru-sawlng"

operations (when sawblade guard must be

removed). Featherboards are used to keep the work

in contact with the fence and table as shown, and to

stop kickbacks.

Add 7-1/2 inch high flat facing board to the fence,

the full length of the fence.

Mount featherboards to fence and table as shown,

so that leading edges of featherboards will support

workoiece until cut is complete, and the workpiece

has been pushed completely past the cutte

(sawblade, dado head, molding head, etc.) with

pushstick, as n ripping.

Before starting the operation (switch "OFF" ant

cutter below table surface):

(a) Instalt featherboards so they exert pressure or

the workpiece: be positive they are secure an€

(b) Make sure by trial that the featherboards wil

stop a kickback if one should occur.

Replace the sawblade guard as soon as the non

thru-sawing operation is complete.

"C" CLAMPS

BOARD

FEATHERBOARD "C'" CLAMPS

WORK SUPPORT

"'C" CLAMPS

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 51 52

Comentários a estes Manuais

Sem comentários

Craftsman 113.298720 Instruções de Operação Página 35

Comentários a estes Manuais