Craftsman 113.298720 Instruções de Operação descarregar pdf (Página 40)

If blade is SQUARE to table;

A. Check pointer

IF POINTER DOES NOT pointto the"0" mark on the

bevel scale:

A. Remove Elevation Handwheel.

B. Loosen screw and adjust pointer . . . using

medium screwdriver.

C. Install Elevation Handwheel.

POINTER

POINTER AT

"O"POSITION

SCALE ADJUSTING

SCREW

If blade is NOT SQUARE tc table.., the 900 LIMIT

STOP must be ADJUSTED.

1. Using amedium sizescrewdriver, loosen BOTH

setscrews in 90° STOP COLLAR.

NOTE: If you can't reach the setscrews, turn the

TILT HANDWHEEL slightly.

2. ROTATE the STOP COLLAR moving it all the

way to the end of TILT SCREW (to the right).

3. TILT blade RIGHT or LEFT... checking with

your square until blade is square to table+

4. ROTATE STOP COLLAR moving it to the right

until it stops,, _TIGHTEN the setscrews.

5. Check POINTER. If it DOES NOT point tothe "0"

mark on the bevel scale.

A. Remove Elevation Handwheel.

B. Loosen screw and adjust pointer . . . using

medium screwdriver.

C. Install Elevation HandwheeL

45 ° STOP COLLAR

TI LT

HANDWHEEL

STOP COLLAR

45° POSITION

TILT blade to LEFTas farasit will go, It will stop

when the PIVOT NUT is against the 45 ° STOP

COLLAR.

A. Place an ACCURATE square against blade.

Make sure square is not touching the TiP of

one of the saw TEETH.

If bladeis45 ° to table;

A. Check pointer.

If POINTER DOES NOT point tothe45 ° mark on the

scale;

A. Remove Elevation HandwheeL

B. Loosen two screws on scale and adjust scale

unt I PC NTER points to 45° mark.

C. install Elevation Handwheel.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 51 52

Comentários a estes Manuais

Sem comentários

Craftsman 113.298720 Instruções de Operação Página 40

Comentários a estes Manuais